Pda Stylus; Recharging The Battery - Baracoda RoadRunners Evolution User Manual

PDA stylus

PDA PDA PDA stylus stylus stylus
In order to attach the PDA stylus to the RoadRunners Evolution, insert the stylus into the hole, as showed in
Fig.1. Note that there are two holes, symmetric around the principal axe of RoadRunners Evolution. Push
downwards, as shown by the arrow n° 2 in Fig.1 till you will hear a clips.
There are two holes, one on both sides.
Note: You will not be able to use the Protective boot and the PDA stylus simultaneously.

Recharging the battery

Recharging the battery Recharging the battery Recharging the battery
Recharge the internal battery by using the included AC adapter or the charging cradle (optional). The Adapter
rating is 5V, 500mA.
When the scanner is charging, the RSL led (left) has the following status: one single long blink red + green
(solid).
When the scanner is fully charged, the RSL led (left) is green (solid).
A full recharge (from completely drained batteries) takes approximately four (4) hours.
When the original batteries wear out, please contact your Baracoda reseller for replacements.
Note: When you insert the RoadRunners Evolution (with its protective boot) in its charging cradle, the scanner
will:
- emit a beep.
- and automatically switch on (if it was off).
Baracoda RoadRunners Evolution – User Guide v1.6
1
2
Fig.1
Data Capture
for Workforce
in Motion
- 7 -