Installing / Replacing Batteries; Switching On The Reader - Baracoda RoadRunners Evolution User Manual

Installing / replacing batteries

Installing / replacing batteries Installing / replacing batteries Installing / replacing batteries
Only use Baracoda approved rechargeable batteries. The use of any other batteries may damage the scanner
and void the warranty. Please remove the batteries when you are storing the scanner for more than 30 days.
To insert batteries into RoadRunners Evolution:
1. Use a coin or your finger to unlock and remove the battery cover at the back of the
RoadRunners Evolution. Turn the lock underneath the scanner to a horizontal
position.
2. Insert the battery lid downwards.
3. Plug the small battery cable into the battery connector (Zone A in Fig. 2).
4. Insert the Baracoda Battery in its location. Pay attention also to well position the
battery connector.
5. Slide the cover up and lock it into place.
Caution. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the
instructions.

Switching on the reader

Switching on the reader Switching on the reader Switching on the reader
Remember to fully charge the battery before first use.
In order to switch on the scanner, please press the trigger button.
The scanner will switch off after some period of inactivity. The default time period is ten (10) minutes of
scanner inactivity if the device is not connected via Bluetooth, and twenty (20) minutes of scanner inactivity if
the device is connected via Bluetooth and if the user don't press the trigger button. These default values can be
modified by the end user.
Baracoda RoadRunners Evolution – User Guide v1.6
Data Capture
for Workforce
in Motion
A
Fig. 2
- 8 -