Ap: / Unit-X / Port-Y / Chan-Z, Fault Management; Ap: / Unit-X / Port-Y / Chan-Z, Performance Management; Table 21: Pm Counter Interval Availability - ABB FOX61 Series User Manual

F O X C S T R E F E R E N C E
8.4.4

AP: / unit-x / port-y / chan-z, Fault Management

ID Fault Cause
MFA Maintenance Function
Active
TSF Trail Signal Failure
RTSF Redundant Trail Signal
Failure
8.4.5

AP: / unit-x / port-y / chan-z, Performance Management

46
Please note:
The z-End of a protected connection shows two entries in the "Connected to
CTPs" table, one for the working and one for the protecting path.
For the a description of the general aspects of the
− "Fault Management - Status", and
− "Fault Management - Configuration"
management functions, please refer to
The following table lists the fault causes of the current AP.
Table 20: AP: / unit-x / port-y / chan-z, Fault Management
Event Type Traffic
Affecting
Communica- 
tion Alarm
Communica- 
tion Alarm
Communica- 
tion Alarm
Please note:
The monitoring of the TSF and RTSF alarms is disabled by default.
For the a description of the general aspects of the performance management
(PM) functions, please refer to
The PM parameters are presented in different groups. The following counter
group is available for the LEDE1 channels:
• "Protection" group, see section
mance Management - Protection" (page
The following counter intervals are available:
Table 21: PM counter interval availability
Counter interval Protection
User Counter yes
History 15min yes
History 24h yes
Alarm 15min no
"1KHW002466 FOXCST
Default Description
Severity
Warning A maintenance function has been acti-
vated by the operator from the channel
status.
Major Trail signal fail (TSF) from the P12 trans-
port unit is active, or
CAS AIS active (only available if CAS is
enabled).
In a protected connection the working
AND the protecting path have failed.
Minor Trail signal fail (TSF) from the P12 trans-
port unit is active, or
CAS AIS active (only available if CAS is
enabled).
In a protected connection the working
OR the protecting path has failed.
In an unprotected connection this fault
cause is not applicable.
"1KHW002466 FOXCST
"AP: / unit-x / port-y / chan-z, Perfor-
47).
Operation".
Operation".

FOX61x LEDE1