Ap: / Unit-X, Fault Management - ABB FOX61 Series User Manual

8.2.3

AP: / unit-x, Fault Management

ID Fault Cause
SWM Software Mismatch
SSWNA Scheduled Software
Not Available
SWIN Software Incompatible
With Network Element
PRC PBUS Resource Con-
flict
EQM Equipment Malfunction Equipment
HWIC Hardware Incompatible
With Configuration
SWIC Software Incompatible
With Configuration
GSW General Software
Alarm
MFA Maintenance Function
Active
UNAV Unit Not Available

FOX61x LEDE1
− "Main - Inventory",
− "Main - Logbooks", and
− "Main - Software"
management functions description, please refer to
Operation".
For the a description of the general aspects of the
− "Fault Management - Status", and
− "Fault Management - Configuration"
management functions, please refer to
The following table lists the fault causes of the current AP.
Table 8: AP: / unit-x, Fault Management
Event Type Traffic
Affecting
Equipment 
Alarm
Equipment 
Alarm
Equipment 
Alarm
Processing 
Error Alarm

Alarm
Equipment 
Alarm
Equipment 
Alarm
Equipment 
Alarm
Communica- 
tion Alarm
Equipment

Alarm
F O X C S T R E F E R E N C E
"1KHW002466 FOXCST
"1KHW002466 FOXCST
Default Description
Severity
Minor The running ESW does not match the
assigned ESW.
Minor The ESW that is scheduled for installa-
tion is not available on the unit. Make
sure that the ESW is downloaded to the
unit.
Major The running ESW is not compatible with
the version required by the NE type or
version.
Major The PBUS access circuit of another TDM
unit in the subrack is defective.
Remove or unassign the other TDM units
in the subrack one by one until the alarm
is cleared. Replace the defective unit.
Critical The LEDE1 controller detects any anom-
alies on the unit, e.g. a voltage is miss-
ing, a chip does not respond, etc.
Major The plugged HW is not compatible with
the unit configuration HW stored in the
database. You may need to change the
HW or re-create the configuration for the
unit.
Major The ESW running on the unit is not com-
patible with the unit configuration stored
in the database. You may need to
upgrade, or downgrade the ESW, or re-
create the configuration with the cur-
rently running ESW.
Major An ESW internal error has been detected
that might inhibit the ESW from running
correctly.
Warning A maintenance function has been acti-
vated by the operator.
Critical The unit that is configured is either not
plugged or not recognized due to a fail-
ure.
Operation".
33