Removing The Usb Flash Drive; Installing The Usb Flash Drive - Lenovo NeXtScale n1200 Installation And Service Manual

10. Start the Setup utility and reset the configuration.

Removing the USB flash drive

Use this information to remove the USB flash drive.
Before you remove the USB flash drive, complete the following steps:
Note: A USB flash drive must be installed for fan power control to maintain
chassis settings after AC cycle.
1. Read "Safety" on page v and "Installation guidelines" on page 25.
2. If the fan power control is installed in the NeXtScale n1200 Enclosure, remove it
3. Carefully lay the compute node on a flat, static-protective surface, orienting the
To remove the USB flash drive, complete the following steps.
Figure 27. USB flash drive removal
1. Locate the USB connector on the fan power control.
2. Pull the USB flash drive out of the connector.
If you are instructed to return the USB flash drive, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Note: If data is not or unable to be migrated from the old USB flash drive onto the
new USB flash drive, you must reconfigure the fan power control settings.

Installing the USB flash drive

Use this information to install the USB flash drive.
Before you install the USB flash drive, complete the following steps:
1. Read "Safety" on page v and "Installation guidelines" on page 25.
2. If the fan power control is installed in the NeXtScale n1200 Enclosure, remove it
40
Lenovo NeXtScale n1200 Enclosure: Installation and Service Guide
9. Install the fan power control into the chassis (see "Replacing an fan power
control" on page 35).
(see "Removing the fan power control" on page 34).
compute node with the bezel pointing toward you.
(see "Removing the fan power control" on page 34).