Removing A Fan Module - Lenovo NeXtScale n1200 Installation And Service Manual

Note: This procedure assumes that you are replacing an existing compute node in
the same node bay. If you are installing a new compute node, see Installing
components section on chapter 2.
To install a 1-bay compute node, complete the following steps.
Figure 17. Installation of a 1-bay compute node
1. Remove the node bay filler, if one is installed. Grasp the filler by the slots and
pull it out of the bay.
2. Open the release handle (rotate the handle to the left).
3. Slide the compute node into the node bay until it is seated.
4. Close the release handle (rotate the handle to the right).
After you install the compute node, make a note of the compute node
identification information on one of the labels that come with the NeXtScale n1200
Enclosure. Place a label on the node label tab and on the adjacent chassis label
plate, to the right or left of the compute node (depending on the bay in which the
compute nodes is installed). See NeXtScale nx360 M4 Compute Node Type 5455
Installation and Service Guide for more information about pull out tag.
Note: If the computer node is pulled out, then you need to put the node filler back
into the empty slot.
Important: Do not place the label on the compute node or in any way block the
ventilation holes.

Removing a fan module

Use these instructions to remove a fan module from the NeXtScale n1200
Enclosure.
To remove a fan, complete the following steps.
32
Lenovo NeXtScale n1200 Enclosure: Installation and Service Guide