Kalfire W60/51Fl Installation And Instructions Manual page 29

Closed wood-burning fireplaces
Table of Contents

Advertisement

Kalfire W53/50R, W65/38C, W90/47C, W66/48S and W90/47S
1. remove the baffle plate and see if this solves the problem.
if the problem still occurs, remove the upper baffle plate. if
the problem still occurs, then something else is the cause.
if removing the plate solves the problem, proceed with the
next step.
2. use a saw to cut away a 3-cm wide strip at the front and the
rear of the baffle plate. if necessary, do this for both baffle
plates.
a 3-sided and a corner fireplace is always a more sensitive
product than a fireplace with a door at the front. particularly
when used with an open door. when the Kalfire w53/50r,
w65/38C, w90/47s, w66/48C of w90/47s s is used as an open
fireplace, some smoke may flow back into the room. even if both
baffle plates have been removed. This may have a number of
causes:
-
insufficient pull in the chimney duct.
-
The air flow patterns in the room where the 3-sided
fireplace has been installed.
-
Too low ignition temperature.
CAREFUL! The Kalfire w53/50r is not suitable to be used
as an open fireplace. only open the door of the firebox if
strictly necessary (e.g. to add logs)
Kalfire W80/52T and W105/47T
1. first remove all baffle plates (6 pieces). if this solves the
problem, it is a good idea to adjust the baffle plates. proceed
with step 2 and/or 3. if the situation remains unchanged,
the appliance is not the cause of the problem, so there is
no point in adjusting the baffle plates, replace them in the
fireplace.
2. To begin, cut a strip approximately 1 cm wide at the front
of the baffle plate using a saw, and check whether this
provides sufficient results. if the result is insufficient, you can
once again cut off a strip and repeat this until the desired
result is achieved.
CAREFUL! Take care that the plates are still able to rest on
the supports.
3. in certain situations, it may be necessary to remove the
baffle plate entirely.
CAREFUL! The Kalfire w80/52T and w105/47T are not
suitable to be used as an open fireplace. only open the door
of the firebox if strictly necessary (e.g. to add logs).
29
Baffle plates
figure 28: w53/50r, w65/38C, w90/47C, w66/48s, w90/47s
Baffle plates
figure 29: w80/52T and w105/47T

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents