Checking Associated Device; Configuring Access Control List - Zte ZXV10 W300 User Manual

Hide SSID: If this option is enabled, this SSID will not be
searched by the wireless terminal devices.
Enable SSID: Choose this option to enable this SSID.
SSID Name: Input an SSID name (1~32 characters).
Priority: Set a priority level: 0~7
Click Submit to complete the configuration of multiple-SSID
settings.

Checking Associated Device

Follow the steps below:
1. Click Network > WLAN > Associated Device to open
the configuration page of the associated device of
wireless connection.
2. Choose an SSID and then click Refresh to refresh the
address of the associated device.

Configuring Access Control List

1. Click Network > WLAN > Access Control List to open
the configuration page of the access control list of
wireless connection.
2. Configure the parameters as described follows:
Choose SSID: Choose an SSID.
Mode: Select a mode (Disabled, Block, and Permit)
MAC Address: Enter the MAC address of the device.
3. Click Add to finish the configuration of access control list.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 - Network Configuration
19