Sony PXW-Z190V Operating Instructions Manual page 30

To record on CH3, CH4
1
Select INPUT1 using Audio Input
(page 77) >CH3 Input Select and
INPUT2 using CH4 Input Select in the
Audio menu.
If INPUT1 is selected using CH4 Input
Select, the sound from the AUDIO INPUT1
connector will be recorded on both CH3 and
CH4.
2
Perform steps 2 and 3 as described in
"To record on CH1, CH2."
Using an external microphone
An electret condenser microphone or other
devices can be connected and used for recording.
To record on CH1, CH2
1
Set the CH1 (INT/EXT/MI SHOE)
switch D and CH2 (INT/EXT/MI
SHOE) switch G to EXT.
When Audio Input >CH2 EXT Input Select
in the Audio menu is set to INPUT2, the
sound from the AUDIO INPUT1 connector
will be recorded on CH1 and the sound from
the AUDIO INPUT2 connector will be
recorded on CH2.
When CH2 EXT Input Select is set to
INPUT1, the sound from the AUDIO
INPUT1 connector will be recorded on both
CH1 and CH2.
2
Set the INPUT1/INPUT2 switches (C/
H).
MIC: For microphone that does not require
phantom power.
MIC+48V: For microphone that requires
+48 V phantom power.
Notes
• Selecting MIC+48V and connecting a
microphone that is not compatible with a +48 V
source may damage the connected device. Check
before connecting the device.
• If noise is a concern on connectors with no device
connected, set the corresponding INPUT1/
INPUT2 switches to LINE.
3
Open the cover by pulling up the handle
of the microphone holder.
4
Attach a microphone, then close the
microphone holder to secure the
microphone.
5
Connect the microphone cable to the
AUDIO INPUT1/AUDIO INPUT2
connectors (A/B).
When you use a stereo microphone (two
XLR plugs), connect the L (left) channel plug
to the AUDIO INPUT1 connector, and the R
(right) channel plug to the AUDIO INPUT2
connector.
To record on CH3, CH4
1
Select INPUT1 using Audio Input
(page 77) >CH3 Input Select and
INPUT2 using CH4 Input Select in the
Audio menu.
If INPUT1 is selected using CH4 Input
Select, the sound from the AUDIO INPUT1
connector will be recorded on both CH3 and
CH4.
2
Perform steps 2 to 5 as described in "To
record on CH1, CH2."
Using a multi-interface shoe compatible
microphone
To record on CH1, CH2
1
Set the CH1 (INT/EXT/MI SHOE)
switch D and CH2 (INT/EXT/MI
SHOE) switch G to MI SHOE.
2
Attach a microphone to the multi-
interface shoe.
To record on CH3, CH4
1
Select Shoe CH1 using Audio Input
(page 77) >CH3 Input Select and Shoe
CH2 using CH4 Input Select in the
Audio menu.
2
Attach a microphone to the multi-
interface shoe.
Note
• Two microphones cannot be connected to the front and
rear Multi Interface Shoe at the same time. The first
connected microphone is the active microphone.
30