Error/Warning Indications; Error Indications; Warning Indications - Sony PXW-Z190V Operating Instructions Manual

Error/Warning Indications

The camcorder informs you of situations where warning, caution, or an operation check is required,
through messages on the viewfinder screen, the recording/tally lamp, and a buzzer.
The warning sound is emitted from the built-in speaker and headphones connected to the headphone
connector.

Error indications

The camcorder will stop operation when the following kind of display occurs.
Error indication on Warning
LCD/viewfinder sound
E + error code Continuous High-speed

Warning indications

Follow the instructions provided if the following display occurs.
Warning indication on
LCD/viewfinder
Battery Near End
Battery End
Temperature High
Voltage Low
Insufficient Voltage
Media Near Full
Media Full
Recording/ Cause and Solution
tally lamp
Indicates an abnormality in the camcorder. Recording stops,
flashing even if "zRec" is displayed in the viewfinder.
Turn off the camcorder, and check for any problem with
connected devices, cables, or media. If the error persists when
the camcorder is turned on again, contact your Sony service
representative.
(If power cannot be turned off by setting the ON/STANDBY
switch to STANDBY, remove the battery pack and/or the DC
IN source.)
An error or warning may not be displayed depending on the
status of the camcorder.
Warning Recording/
sound tally lamp
Intermittent Flashing
Continuous High-speed
flashing
Intermittent Flashing
Intermittent Flashing
Continuous High-speed
flashing
Intermittent Flashing
Continuous High-speed
flashing
107
Cause and Solution
The remaining capacity of the battery pack is
getting low.
Recharge at the earliest convenience.
The battery pack is empty. Recording cannot be
performed.
Stop operation and replace the battery pack.
The internal temperature is high.
Turn off the camcorder and allow it to cool down
before operating it again.
The DC IN voltage is low (level 1). Check the
power supply.
The DC IN voltage is too low (level 2). Recording
cannot be performed.
Connect a different power source.
Free space on the memory card has become
insufficient.
Replace at the earliest convenience.
No space is left on the memory card. Recording,
clip copying and clip division cannot be performed.
Replace immediately.