Cisco IE-4000 Software Configuration Manual page 1064

Using an SD Card
SD Card Alarms
parameters on the source flash device that is specified in the sync command. By default, this command overwrites
the destination IOS image directory and IOS configuration files. The "save-old-files" option can be used to override
this default behavior. If the running configuration has not been saved and you run the sync command, the switch
provides the option for you to save the running configuration before the command executes.
The sync command options are:
— Switch# sync flash: sdflash:—Sync IOS image directory, configuration files, and boot parameters from internal
flash memory to SD card.
— Switch# sync sdflash: flash:—Sync IOS image directory, configuration files, and boot parameters from SD card
to internal flash memory.
— Switch# sync flash: sdflash: ios-image-name IOS_image_path—Sync the designated IOS image directory,
configuration files, and boot parameters from internal flash memory to SD card. For example, IOS_image_path
might be flash:/ie2000-universalk9-mz.150-2.EA1/ie2000-universalk9-mz.150-2.EA1.bin.
— Switch# sync sdflash: flash: ios-image-name IOS_image_path—Sync the designated IOS image directory,
configuration files, and boot parameters from SD card to internal flash memory. For example, IOS_image_path
might be flash:/ie2000-universalk9-mz.150-2.EA1/ie2000-universalk9-mz.150-2.EA1.bin.
— Switch# sync flash: sdflash: skip config.text vlan.dat—Sync only IOS image directory from internal flash
memory to SD card.
— Switch# sync sdflash: flash: skip config.text vlan.dat—Sync only IOS image directory from SD card to internal
flash memory.
— Switch# sync flash: sdflash: skip ios-image—Sync only IOS configuration files from internal flash memory to
SD card.
— Switch# sync sdflash: flash: skip ios-image—Sync only IOS configuration files from SD card to internal flash
memory.
SD Card Alarms
The switch supports the following SD card alarms:

SD Card Alarm—Enabled when the SD card is removed and cleared when the SD card is inserted

SD Card Unsupported Alarm—Enabled when an unsupported SD card is detected

SD Card Corrupt Alarm—Enabled when an SD card DOSFS corruption is detected

SD Card Files Corrupt Alarm—Enabled when the IOS image specified in the SD Card system boot path is corrupted
It takes approximately 2 minutes to trigger the alarm relay (LED output) after an SD card is inserted or removed.
You also can configure alarms and traps that are associated with the SD card alarm to be sent to syslog and the SNMP
server.
Enabling SD Card Alarms
SD card alarms are disabled by default.
To use alarms, enter the alarm facility sd-card enable global configuration command to enable alarms, then enter the
alarm facility sd-card global configuration commands to associate the alarm to the relay:
Switch(config)# alarm facility sd-card enable
Switch(config)# alarm facility sd-card notifies
1060