Laars MagnaTherm MGH1600 Installation And Operation Instructions For page 99

MagnaTherm Boilers and Water Heaters
184 Invalid BLOWER / SPARK output setting
185 Invalid Delta T limit enable setting
186 Invalid Delta T limit response setting
187 Invalid DHW (Domestic Hot Water) high
limit enable setting
188 Invalid DHW (Domestic Hot Water) high
limit response setting
189 Invalid flame sensor type setting
192 Invalid igniter on during setting
193 Invalid ignite failure delay setting
194 Invalid ignite failure response setting
195 Invalid ignite failure retries setting
196 Invalid ignition source setting
197 Invalid interlock open response setting
198 Invalid interlock start check setting
199 Invalid LCI (Limit Control Input) enable
setting
200 Invalid lightoff rate setting
201 Invalid lightoff rate proving setting
202 Invalid MFEP (Main Flame Establishing
Period) time setting
203 Invalid MFEP (Main Flame Establishing
Period) flame failure response setting
204 Invalid NTC sensor type setting
205 Invalid Outlet high limit response setting
207 Invalid PII (Pre-Ignition Interlock) enable
setting
210 Invalid Postpurge time setting
211 Invalid Power up with lockout setting
212 Invalid Preignition time setting
213 Invalid Prepurge rate setting
214 Invalid Prepurge time setting
215 Invalid Purge rate proving setting
216 Invalid Run flame failure response
setting
217 Invalid Run stabilization time setting
218 Invalid Stack limit enable setting
219 Invalid Stack limit response setting
220 Unconfigured Delta T limit setpoint
setting
221 Unconfigured DHW (Domestic Hot
Water) high limit setpoint setting
222 Unconfigured Outlet high limit setpoint
setting
223 Unconfigured Stack limit setpoint setting
L
L
L
L 1. Return to Configuration mode and recheck
selected parameters, reverify and reset module.
L
2. If fault repeats, verify electrical grounding.
3. If fault repeats, replace module.
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
L
Page 95