Setup Procedures - Ferris 400S Series Dealer Setup & Adjustment Instructions Manual

Setup Procedures

The items in this section provide the information necessary
to fully assemble, test, and prepare the unit, that these
instructions were included with, for delivery to your customer.
The Quick Setup List provided on page 2 of this booklet
to help you identify and check that the items have been
performed.
Uncrating
1. Install the parking brake handle (A, Figure 1) onto the
parking brake lever (B) located on the instrument control
panel using the #8 X 3/8" bolt (C) and #8 hex nut (D).
Note: The parking brake handle, parking brake handle
mounting hardware, and seat mounting hardware are in a zip
lock bag wire tied to the bottom side of the seat plate on the
unit.
1
2. Locate the transmission release levers (A, Figure 2) on
the rear of the machine beneath the bumper. There is
one transmission release lever on each transmission.
The transmission release levers open and close the
transmission bypass valves.
2
3. To open the transmission bypass valve (bypass position)
(B), pull the transmission release lever out towards the
rear of the rider and push it towards the rear tire. Repeat
this process for the other side of the rider.
4. Disengage the parking brake.
5. Be sure there are no sharp objects to puncture the unit's
tires. Roll the unit forward off of the bottom skid.
6. After moving the rider, close the bypass valve (run
position) (C) by pushing the transmission release lever
towards the center of the machine and then pushing it
towards the front of the rider. Repeat this process for the
other side of the rider.
Note: Both transmission release levers must be in the same
position.
7. Cut the cable ties that secures the foam around the
body of the rear shocks. Remove the foam from the rear
shocks.
8. Remove the bolts, (A, Figure 3), washers (B), and nylock
flange nuts (C) from the bottom hole of the rear shocks
(D).
3