GatesAir Intraplex T1 DCS-9530 CrossConnect System Installation And Operation Manual page 95

T1 CrossConnect Installation & Operation Manual
Version 2
Table 6-5. Valid
:DCS:CONFIG?:
Parameter Possible Response
FLAGS4 DLY3
DLY4
FLAGS5 CLOCK=<n>,<n>
LEVEL
FTYP5
CODE5
FTYP6
CRC45
CODE6
CRC46
FLAGS6,<p>
FTYPE,<p>
CODE,<p>
EFAST,<p>
LOSDLY,<p>
NORM,<p>
NODE,<p>
MPORT,<p>
SPORT,<p>,1
SPORT,<p>,2
SPORT,<p>,3
SPORT,<p>,4
SPORT,<p>,5
SPORT,<p>,6
FLAGS7 DLY5
DLY6
FLAGS8 EXTERNAL ENABLE
FLAGS10 REQUESTED MAP
NORMAL MAP
LINE LOOPBACK1
LINE LOOPBACK2
LINE LOOPBACK3
LINE LOOPBACK4
LINE LOOPBACK5
LINE LOOPBACK6
6-14
Parameters and Responses (continued)
Switch time delay for port 3
Switch time delay for port 4
Clock source=
<alt1>,<alt2>
Strength level of received signal
Frame format, port 5
Line code, port 5
Frame format, port 6
CRC-4 status, port 5
Line code, port 6
CRC-4 status, port 6
<p> is the T1 port (framer) number (1–6)
Frame format, port
<p>
Line code, port
<p>
Fast switching enabled, port
Loss of synch delay, port
Normal switching mode
Critical node (loss of all ports if failure)
Enable Multiple Port, port
Secondary Port 1
Secondary Port 2
Secondary Port 3
Secondary Port 4
Secondary Port 5
Secondary Port 6
Switch time delay, port 5
Switch time delay, port 6
Returns a value in the format
enabled state of an external input (1=on, 0=off).
Active map number
Normal map number (0 or 7)
Loopback on or off, port 1
Loopback on or off, port 2 (LINE/OFF)
Loopback on or off, port 3
Loopback on or off, port 4
Loopback on or off, port 5
Loopback on or off, port 6
6 – Configuration Using ISiCL
Description
(port number)
(yes/no)
<p>
<p>
<p>
where each
bbbbbbbb:
Intraplex Products
represents the
b
GatesAir