Advertisement
1. C
ONNECTING THE
The 8006L1-1CR device can be used to connect with PC/ terminal. It supports RS232, USB
interfaces via different cable types such as DB9 (Figure 1) and standard USB (Figure 2) connector.
Input voltage/current:
5V/500mA for 8006L1-1CR USB or 12V/500mA for 8006L1-1CR DB9
AC adapter for DB9: HON-KWANG ELECTRIC Co.,LTD HK-AX-120A200-EU
Input: 100-240Vac/0.8A, 50/60Hz.
Output: 12V/2.0A
Operating Temperature: 0
Note: Turn off or unplug the PC/terminal whenever you connect or disconnect the PIN Pad. Be
sure the PC/terminal is not processing data when powered off.
Figure 1
Caution: The cover (Figure 3) shall be provided with a means to keep it closed during normal
operation.
Warning: This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
2. U
C
SING
ARD
M
S
AGNETIC
Find the card reader slot at the right side of PIN Pad.
Slide the card in either direction through the slot without stopping. If the card swipe fails, check
the position of the magnetic stripe and slide the card again. (Figure 4)
S
C
MART
ARD
Find the card reader slot on bottom of PIN Pad. Please insert the card completely and make sure
that it cannot be moved forward anymore. If inserted failed, check the position of the card and
insert the card again. (Figure 5)
C
ONTACTLESS
Contactless reader is on the top of 8006L1-1CR. It will light up and blink with first green color
signal when 8006L1-1CR is powered on and that means reader is working normally.
Put contactless card to approach the signal icon in the middle area of card reader (Figure 6) for
reading the card data during transaction.
Figure 4
8006L1-1CR PIN PAD
~40
℃
R
EADER
R
TRIPE
EADER
R
EADER
R
EADER
℃
Figure 2
Figure 5
Figure 3
Figure 6
Advertisement
