Omron ERT1 Series Operation Manual page 71

Screw-less Clamp Terminals
Component Names and Functions
(2)
(3)
Indicators
Communications
Indicators
(7)
(1)
(4)
(5)
(1) Rotary Switches
These switches are used to set the node address.
(2) Ethernet Connector
The network communications cable is connected to this connector.
(3) Power Supply Connector
The communications and Unit power supply is connected to this connector.
24 V DC
Applicable Ferrules
Manufacturer
Phoenix Contact
Nihon Weidmuller
(4) Communications Indicators: MS and NS
These indicators show the Unit communications status and network commu-
nications status.
(5) and (6) Terminal Blocks 1 and 2
The output devices and output power supply are connected to these terminal
blocks.
(7) and (8) Output Indicators
These indicators show the ON/OFF status of the outputs and the error status
of connected devices.
Refer to 3-1-3 Communications Indicators.
Terminal
+
−
0 V DC
Model
AI-0.5-10
H 0.5/16 D
Section 4-2
(8)
(6)
Specification
24 V DC
0 V DC
Applicable wire size
2
0.5 mm (AWG 20)
2
0.5 mm (AWG 20)
51