Omron ERT1 Series Operation Manual page 66

Screw-less Clamp Terminals
Wiring to a Clamp Terminal Block
Insertion
Removal
Screwdriver Used to
Remove Ferrules
Removing and Mounting a Clamp Terminal Block
Removal
Mounting
46
Insert the ferrule all the way to the end in any terminal hole.
Pull out the power line while pressing down with a small flat-blade screwdriver
on the release button above the terminal hole.
Small flat-blade screwdriver
Release button
You will need a screwdriver that is consistently thin for the entire length.
3.0 mm max.
Recommended Screwdriver Model
Model
SZF1 Phoenix Contact
Use a flat-blade screwdriver to loosen the four screws on the top of the termi-
nal block, and then grasp the handles on both sides and remove the terminal
block.
Grasp the handles on both sides of the terminal block, and insert the terminal
block firmly in place. Then use a flat-blade screwdriver to tighten the four
screws on the top of the terminal block.
Four 2.6 x 6 standard screws
Note Tighten the screws to a torque of 0.2 to 0.25 N·m.
0.5 mm max.
Manufacturer
1
Grasp handles on both sides.
Pull out the terminal block.
Section 4-2
2
1