Setting The Date - Mercedes-Benz Vito 111 CDI/BlueTEC Operating Instructions Manual

On-board computer (vehicles with steering wheel buttons)
240
If the display shows the speed in the header, the
display shows the outside temperature with the
Y
odometers ( page 231). The additional speed-
ometer unit in the header is always inverse to
the speedometer unit.
Use the steering wheel buttons.
X
Press = or ; to select the
menu.
X
Press : or 9 to select
ter.
X
Press a to confirm.
X
Press : or 9 to select
display:.
X
Press a to confirm.
The display shows the current selection of
outside temp.
X
Press a to change the setting.
Clock/date submenu
Setting the time
Using the steering wheel buttons
X
Press = or ; to select the
menu.
X
Press : or 9 to select Time/date.
X
Press a to confirm.
X
Press : or 9 to select the
tion.
The display shows the current time.
X
To set the time: press a again.
X
Press = or ; to switch between hours
and minutes.
X
Press : or 9 to set the hours or
minutes.
X
Then press a to confirm.
The display shows the updated time.

Setting the date

Using the steering wheel buttons
X
Press = or ; to select the
menu.
X
Press : or 9 to select Time/date.
X
Press a to confirm.
X
Press : or 9 to select the
tion.
The display shows the current date.
X
To set the date: press a again.
Sett.
Inst. clus‐
Permanent
or dig. speedo.
Sett.
Time
Sett.
Date
X
Press = or ; to switch between day,
month and year.
X
Press : or 9 to set the day, month or
year.
X
Then press a to confirm.
The display shows the updated date.
Lights submenu
Activating/deactivating the Intelligent
Light System
Using the steering wheel buttons
X
Press = or ; to select the
menu.
X
Press : or 9 to select Lights.
X
Press a to confirm.
X
Press : or 9 to select the
Light System
The current status is shown.
X
To activate/deactivate: press a again.
When you activate the
function, you activate the following functions:
Motorway mode
R
Active light function
R
Cornering light function
R
Extended range foglamps
R
func-
If you set the dipped-beam headlamps for driv-
ing on the right/left, the display shows the
Intell. Light System inactive Inac‐
tive for left-side traffic or Inac‐
tive for right-side traffic
sage instead of the
tem
function in the
Y
( page 240). This display message will only
appear if the setting for driving on the left/right
is set opposite to your vehicle's country version.
Further information can be found under "Intelli-
gent Light System" (
Setting the dipped-beam headlamps for
driving on the left/right
This function is only available on vehicles with
the Intelligent Light System. When travelling
abroad you can switch between symmetrical
and asymmetrical dipped beam using the on-
func-
board computer (
Sett.
Intell.
function.
Intell. Light System
display mes-
Intelligent Light Sys‐
Lights
submenu
Y
page 117).
Y
page 180).