Information About Sensor Features - Panasonic KX-HNS104 Installation Manual

Setup
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks in green.
2
Sensor:
Press and hold M
LED indicator blinks in green
(page 8).
R When registration is complete,
Note:
R To cancel the registration, press
M
R If registration fails, the hub sounds
several short beeps.
Using the app
When you register the sensor by using
the [Home Network] app, you can
assign a name to your devices and
group them by location. For more
information, refer to the User's Guide
(page 14).
Information about
sensor features
Please read the following information
before deciding where to install the
sensor.
Note:
R The sensor's features are not
designed to be used in situations
that require high reliability. We do
not recommend use of the sensor's
features in these situations.
R Panasonic takes no responsibility for
any injury or damage caused by the
use of the sensor.
10
HNS104_(en_en)_1120_ver.010.pdf
OTHER
N until the
the hub sounds one long beep.
N on the hub and on the sensor.
For assistance, please visit www.panasonic.com/support
10
Glass break sound detection
The sensor uses a microphone to
detect the unique sound frequencies
that are produced when glass breaks.
1
Sensor detection range (when set to
MHIGHN):
: approx. 5 m (16.4 feet)
1
Note:
R The sensor may make false
detections when there is noise from
metallic blinds opening and closing,
metallic bells of alarm clocks, etc.
Applicable glass specifications
Type Thickness
xxxx Minimum: xx mm
(xx inches)
Maximum: xx mm
(xx inches)
xxxx Minimum: xx mm
(xx inches)
Maximum: xx mm
(xx inches)
検知可能なガラスの仕様について記載予定
です。
詳細については、電気ご担当者様と確認中
です。
2014/11/19 19:59:09