Ad-Hoc Wibox Connection; Protocol Support - Lantronix WiBox User Manual

In Error! Reference source not found., the WiBox communicates with another
device server via the AP. The device server (in this example, the UDS) is connected
via an Ethernet connection to the AP. As such, the WiBox and the device server
communicate directly and can transfer information between their serial devices.

Ad-Hoc WiBox Connection

In the above example, two WiBoxes have established an Ad-Hoc point-to-point
relationship. They communicate directly to each other's serial devices without a PC
or an AP.

Protocol Support

The WiBox device server uses the TCP/IP protocol stack for network
communications. Other supported protocols include:
WiBox™ User Guide
Figure 2-3. Serial Tunneling Infrastructure Example
Figure 2-4. Direct WiBox to WiBox Connection
ARP, UDP, TCP, ICMP, Telnet, TFTP, AutoIP, DHCP, HTTP, and SNMP for
network communications and management.
TCP, UDP, and Telnet for connections to the serial port.
TFTP for firmware and web page updates.
Introduction
13