Ers 5600 Single Connection To Hirschmann™ Switches; Procedure Steps; Figure 5 - Ers 5600 Single Connection To Hirschmann™ Switches - Avaya Hirschmann MACH1040 Technical Configuration Manual

5. ERS 5600 single connection to
Hirschmann™ switches
The objective of this test is to establish connectivity between the ERS 5600 and all three of the
Hirschmann™ switches used in this testing.
The following figure represents the topology for this test:
Figure 5 – ERS 5600 single connection to Hirschmann™ switches

5.1 Procedure steps

1. Set up a single connection between the ERS 5600 and the Hirschmann™ MACH1040.
2. Test basic interoperability of link auto-negotiation (half/full duplex and 10/100/1000 Mbps).
3. Test on both copper and fiber ports.
4. Connect the ERS 5600 to the Hirschmann™ RS30 and repeat steps 2 and 3.
5. Connect the ERS 5600 to the Hirschmann™ MS30 and repeat steps 2 and 3.
Note: This test uses Port 1/3 as the connection to the Hirschmann™ switches. It also uses only one
VLAN (VLAN 1).
June 2011
ES470 Stack
PC1
ERS5600
Avaya Inc. – External Distribution
ERS 5000 Series with Hirschmann™ IE Switches TCG
Hirschmann Switch
1
PC2
avaya.com
13