Kenwood NX-5800 Service Manual page 47

4.8 Common Section
Item Condition
Panel tuning
mode
1. 1) DC voltage:13.6V
Setting 2) SSG standard modulation
[Wide] MOD:1kHz,DEV:3kHz
[Narrow] MOD:1kHz,DEV:1.5kHz
2. 1) Adj item: 1) Adj item:
Receive [RAST] [Receive Assist]
Assist Adjust:[****] 2) Adj item:
2) Adj item: [Low1],[Low2],
[Low1 RAST]→ [Low3],[Low4],
[Low2 RAST]→ [Low5],[Low6],
[Low3 RAST]→ [Center1], [Center2],
[Low4 RAST]→ [Center3], [Center4],
[Low5 RAST]→ [Center5],
[Low6 RAST]→ [High1],[High2]
[Center1 RAST]→ [High3],[High4]
[Center2 RAST]→ [High5],[High6]
[Center3 RAST]→
[Center4 RAST]→
[Center5 RAST]→
[High1 RAST]→
[High2 RAST]→
[High3 RAST]→
[High4 RAST]→
[High5 RAST]→
[High6 RAST]→
Adjust:[****] Press [Apply All] but-
Press [ ] key ton to store the ad-
to store the ad- justment value.
justment val-
ue.
Measurement
PC test mode Test-
equip-
ment
Adjustment
Unit Ter- Unit Parts
minal
Panel [Panel
tuning
mode]
[],
[]
[PC
test
mode]
[←],
[→]
Specifications
Method
[PC test mode] 2.5V±0.1V
[Automatic Adjust- [Automatic Ad-
ment] justment]
1) Press [Tune Assist After the automatic
Voltage] button. adjustment is per-
2) Press [Apply All] but- formed, verify that
ton to store the adjust- the VCO lock volt-
ment value after the age is within the
automatic adjustment voltage range
has finished. which is specified
[Manual Adjustment] by the manual ad-
[V] indicator on the PC justment.
window shows VCO lock [Manual Adjust-
voltage. Change the ad- ment]
justment value to get Press [Apply All]
VCO lock voltage within button to store the
the limit of the specified adjustment value
voltage. after all adjustment
point have been
Note:
adjusted.
Confirm the VCO lock
voltage approximately Note:
3 seconds after the The assist adjust-
adjustment value is ment value must
changed. be between from
340 to 3550.
(No.RA017<Rev.003>)1-47
/Remarks