Kenwood WD-K10PBS User Manual page 21

Note:
The Portable base WD-K10PBS (Transceiver Mode only) or
●
Transceiver WD-K10TR can be registered as a sub unit.
A sub unit can also be registered using the Programming Software
●
WD-ZS10. For details, refer to the Programming Software WD-ZS10
User Guide.
For details on registering a sub unit that uses Base Station WD-
●
K10BS, refer to the USER GUIDE of WD-K10BS.
1 If the base and sub units are turned on, turn off the power by
pressing and holding the [Power] key until the Status LED
goes off.
2 While pressing the [All Call] key on the base unit, press and
hold the [Power] key.
The unit enters into registration mode. The Status LED lights up in
green and all the Group LEDs blink.
3 While pressing the [All Call] key on the sub unit, press and
hold the [Power] key.
The sub unit enters into registration mode. The Status LED lights up
in green and all the Group LEDs blink.
The registration begins automatically when both the base unit and sub
unit are in registration mode.
When registration is successful:
The Status LED of the sub unit lights up in green and all the Group
LEDs light up.
When registration has failed:
The Status LED of the sub unit lights up in green but all the Group
LEDs do not light up. Restart the units in registration mode and
register again.
All sub units are registered to the same group (Group A) by default.
●
4 Turn on the power of the sub unit to restart it.
When registration of sub unit is successful, restart the sub unit.
After the registration is complete, restart the base unit as well.
Note:
To exit registration mode, press and hold the [PF 2] key.
●
If registration fails repeatedly, the maximum number of registrations
●
may have been exceeded.
19