Basic Operations; Turning Power On/Off - Kenwood WD-K10PBS User Manual

CAUTION
Operation marked with * cannot be executed by default.
●
To execute the operation, it is necessary configure the setting using
the Programming Software WD-ZS10. To configure the setting, use
the Programming Software WD-ZS10 or consult the authorized
dealer or installer.
If the function assigned to a key cannot be executed, a key failed
alert tone is sounded. And if a function is not assigned to the key,
there is no operation tone even when the key is pressed.
The default key name or functions assigned to the [PF 1] / [PF 2]
●
are described in this manual. To assign a function to transceiver or
to configure a setting, use the Programming Software WD-ZS10,
or consult the authorized dealer or installer.

TURNING POWER ON/OFF

Turning on the power
o
1 Press and hold the [Power] key for 2 seconds or more.
The Status LED (red), Group LED and Battery Charge LED lights up.
Base Station Mode:
When the unit is linked to the system, the Status LED blinks in orange
and enters into group call mode.
Transceiver Mode:
When the unit is linked to the system, the Status LED blinks in green
and enters into group call mode.
When the unit is unable to link to the system, the Status LED lights up
in red.
Move to a location where linking is possible.
Turning off the power
o
1 Press and hold the [Power] key until the Status LED goes off.
The unit is turned off.
20

BASIC OPERATIONS