Walinga Agri-Vac 3510 Operator's Manual And Parts Book page 55

5. Changing Oil:
a. Place a collection pan or pail under each drain
plug.
b. Remove each drain plug.
c. Flush each case and allow several minutes to
drain.
d. Dispose of the oil in an approved manner. Do
not contaminate the worksite with used oil.
e. Install and tighten the drain plugs.
f. Remove ll and level plug.
®
g. Add Walinga Blower oil or equivalent to each
reservoir until the oil is just starting to come
out of the level plug hole or half way in sight
glass.
IMPORTANT
Condensation forms and collects inside
the reservoirs during machine operation.
Changing oil removes this water and
prevents it from damaging the gears
and bearings.
h. Install and tighten the level and ll plugs.
i. Install and secure the belt/chain drive covers.
6. Cleaning Breathers:
a. Remove breathers and blow out with an air
hose.
b. If dirt has caked up in the breather, soak in
good solvent and then blow out. It may be
necessary to use a probe to loosen the dirt.
c. Install and tighten the breather.
e. Install and secure the belt drive covers.
f. Clean vents in end plates located under the
blower on either side of the drain plug.
Schematic
Blower (Typical)
FIG. 32 BLOWER
45