Walinga Agri-Vac 3510 Operator's Manual And Parts Book page 48

5.2.2 CHANGING ENGINE OIL AND FILTER
1. Review the Operator's Manual for the engine.
2. Place all controls in neutral, stop engine, remove
ignition key and wait for all moving parts to stop
before maintaining.
3. Allow the engine to cool before changing the oil.
Hot oil can cause burns if it contacts exposed skin.
It is best to change oil while the engine is warm to
keep the contaminants in suspension.
4. Place a pan under the drain plug.
5. Remove the drain plug and allow the oil to drain for
10 minutes.
6. Install and tighten the drain plug.
7. Dispose of the used oil in an approved container.
8. Remove engine oil lter.
9. Apply a light coat of oil to the O-ring and install
the replacement lter. Snug up by hand and then
tighten ½ turn.
10. Fill the crankcase with the speci ed oil.
11. Run the engine for 1-2 minutes and check for oil
leaks.
12. If leaks are found around the drain plug tighten
slightly. Repeat step 9.
13. Check engine oil level. Top up as required.
38
c
a. Drain Plug
c. Dip Stick
FIG. 24 ENGINE OIL AND OIL FILTER
b
d
a
b. Fill Plug
d. Oil Filter