Input Submenu - Extron electronics VN-Matrix 250 Series User Manual

IP address
•
Subnet mask
•
Gateway
•
— use either rotary encoder to adjust the
MTU
•
ATTENTION:
•
•
•
•
— use either rotary encoder to toggle between
Mode
•
modes.
— use either rotary encoder to toggle between
DHCP
•
System Control
The
System Control
of the system controller.
number

Input Submenu

The
Input
through video signal, and enable or disable the power save feature for the loop-through
signal.
MENU
Figure 79.
— follow steps 1 through 4 of the Control section on the previous page.
— follow steps 1 through 4 of the Control section.
— follow steps 1 through 4 of the Control section.
The setting adjusts the data payload in each network packet. The default
MTU
setting of does not normally require adjustment.
1500
Le paramètre ajuste la charge utile de données dans chaque paquet
MTU
réseau. Le paramètre par défaut
ajustement.
All devices in the network should be set to the same value. Setting different
values for different devices may cause failures in the VN-Matrix streaming
network.
Tous les appareils du réseau doivent avoir la même valeur. Un paramétrage
avec des valeurs différentes sur plusieurs appareils peut entraîner des
défaillances dans le réseau de streaming VN-Matrix.
editing screen allows you to configure the
submenu allows you to select the input source, enable or disable the loop-
Input
Select
NEXT
NEXT
input
NEXT
Loop through
[Enabled]
NEXT
Power save
[Enabled]
NEXT
VNE 250 Encoder Input Submenu
value ( -
MTU 150 9000
ne nécessite généralement aucun
1500
and
100 Mbps
and
enable
IP address
Select: auto
auto
HDMI
VGA
Select: Enabled
Disabled
Select: Enabled
Disabled
VNM 250 • Front Panel Menu Configuration
).
network
1000 Mbps
.
disable
and
port
97