Filling up with fuel
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends you use the STIHL filler
nozzle (special accessory).
Closing screw-type tank cap
Place the cap in the opening.
N
Turn the cap clockwise as far as
N
stop and tighten it down as firmly as
possible by hand.
KM 56 R, KM 56 RC
Starting / Stopping the
Engine
Controls
3
1
2
1
Throttle trigger lockout
2
Throttle trigger
3
Stop switch with Run and 0 = Stop
positions.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position, i.e. when it is not depressed:
The ignition is switched on – the engine
is ready to start. If the stop switch is
moved to the 0 position, the ignition is
switched off. The ignition is switched on
again automatically after the engine
stops.
Starting the Engine
4
Press the manual fuel pump
N
bulb (4) at least five times – even if
the bulb is filled with fuel.
Cold engine (cold start)
5
Press in the choke lever (5) and turn
N
it to g at the same time.
Warm engine (warm start)
5
Press in the choke lever (5) and turn
N
it to < at the same time.
English
13