Fire Safety; Fastening The Stove; The First Use - KIRAMI Premium Grandy Instructions For Use Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 23
26/64
© Kirami Oy, Finland
If you have purchased a firewood heater for your tub then read pages 3-5, otherwise you
can mode directly to page 6.

FIRE SAFETY

In case the tub has a firewood heater and is placed near buildings, e.g. the edge of a terrace, ensure
that the chimney top is located away from flammable materials. Remember to check the distance
both sideways and vertically in order to avoid
the risk of fire. The distance from chimney top
should be three metres to any flammable
material. A smaller distance is sufficient for
the pipe of chimney. In case the chimney is
closer, use a separately insulated chimney.
When near a roof or when running the
chimney through the roof, the end of the
insulated chimney needs to be one metre
above the roof.
There should be no flammable material
located in front of and below the furnace. In
practical terms, this means that an area of
incombustible material, such as concrete,
sand, or a metal plate, is needed in front of the furnace. The stove will not heat up above the water
temperature as the stove is surrounded by a water jacket. The chimney and door of the stove will
heat up, however. Ask more from a local fire authority.

Fastening the stove

If you have purchased a heater with the tub it has to be connected according to the heater model
instructions.
The tub has matching connectors installed at the factory if a full kit has been ordered. And also a
longer connection hose is supplied since the standard rubber hose with the heater is too short for
the Grandy tub.
Chimney
Be careful, the edges of the chimney are very sharp. Use protective
gloves! The chimney is delivered in a separate box and it consists of four
parts (picture on right) and it needs to be assembled. Remove the
protective film from the thermal protection and place the assembled
chimney to the chimney outlet of the stove.

The first use

The water circulation of the stove shall be rinsed by letting plenty of water in from the pipe above,
so that any metal chips from grinding come out. Collect any trash by swiping it off the bottom of the
tub. When you fill the tub, check the fastening pipes of the stove for any leakages.
INSTRUCTIONS FOR USE: Kirami Premium Grandy
4 / 10
01.06.2018

Advertisement

Table of Contents
loading

Table of Contents