Stil/A Series Touch Control Panels; Preparation And Filling; Power; Priming The Pumps - BullFrog STIL7 Owner's Manual

STIL/A SERIES TOUCH CONTROL PANELS

A Series Contol
STIL Control
Jets 1
Jets 2
Lighting
Menu
Invert
Screen
Water Temperature
Time
Lock
Indicator Indicator
Message Center
Heating Status Indicator

Preparation and Filling

Fill the spa to its correct operating level. Be sure to open all
valves in the JetPaks and all other jets in the spa before filling to
allow as much air as possible to escape from the system during
the filling process. For details see "Filling your spa" section. After
turning the power on at the main power panel, the control panel
display will go through an initializing sequence. This sequence
displays information regarding the configuration of the hot tub
control. After a few seconds, your control will display a standard
status screen with time, jet and light status, temperature status,
operation mode, etc.

Power

Press any button to turn the keypad on. After 30 minutes without
activity it will shut off.

Priming the Pumps

After initial start up, verify that the home status screen appears on
the panel. Pumps must be primed directly after filling to ensure
correct operation of your spa. To prime the pumps press the
"Jets 1" button once to prime in low-speed. After the pump turns
on wait a few seconds and then press
high-speed operation of Pump 1. The pump has primed when the
jets are running with water flowing from the jets. Press the
"Jets 1" button again to turn off Pump 1.
If your spa is equipped with a second jet pump repeat the priming
process for Pump 2 by pressing the
turn on low speed and then a second time to turn Pump 2 on
high. Each pump should run for 4-5 minutes at their highest
speed to complete priming. Prime each pump separately and turn
Wi-Fi Desired Temperature
Adustment
"Jets 1" again to initiate
"Jets 2" button once to
Temperature
Menu
Audio
Screen
Contrast
Settings
Menu
12