Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for BullFrog M Series
Summary of Contents for BullFrog M Series
- Page 1 BULLFROG SPAS Delivery and Installation Guide...
- Page 2 INSTALLATION & DELIVERY Note In addition to handling the water from the spa, it is : when you purchase a Bullfrog Spa through Costco, standard backyard delivery is included with your hot tub. recommended that the room be properly ventilated. Humidity This includes a 2-man delivery and does not include the levels will naturally increase after the spa is installed and in use.
- Page 3 18 inches (.61m) of clearance Access to Circuit Breakers: For service purposes, allow behind the spa. Check with your authorized Bullfrog Spas easy access to the circuit breakers in the electrical service panel Dealer for the exact clearance requirements for the cover-lifting (permanently connected models), or to the interrupter switch on mechanism.
-
Page 4: Delivery Basics
Corner Radius for A, & R, & X Models is 8” (0.3937m) Corner Radius for M Series & STIL Models is 2.5” proper spa-side accessories will provide just the finishing touch that you are looking for. -
Page 5: Installation
GFCI disconnect to the spa” the spa and do not use the spa until the malfunction has been Spa Location: repaired by a licensed Electrician or your authorized Bullfrog Spa dealer. Overhead Power Lines: Based upon the national and local wiring... - Page 6 If there is not Cord-Connected 120V~/60Hz spas require that the factory 50A of electrical service available, an authorized Bullfrog Spa installed power cord, with its built-in GFCI breaker be connected dealer or Electrician can easily convert the spa to operate on 30A...
- Page 7 To conform with electrical codes, and to create a barrier conduit drill 1-3/8” hole). Use the + as the locater for the center against pests, any holes created in the base of your Bullfrog Spa of the hole. The hole saw must go through two layers of plastic.
- Page 8 Electrical Chaseway Diagrams THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF BULLFROG INTERNATIONAL, ANY REPRODUCTION IN PART OR WHOLE WITHOUT THE WRITTEN PERMISSION OF BULLFROG IS NOT ALLOWED. 237.86 93.6 FROM BOTTOM OF BASE 86.7 FROM BOTTOM OF BASE 39.70...
- Page 9 228cm From Bottom of Base 73cm 83.3 [211.6] FROM BOTTOM 88.0 OF BASE 32.8 [83.4] 83.7 Model A9L [212.6] 267cm FROM From Bottom 7'10" (2.39m) x 9'2" (2.79m) x of Base BOTTOM Model A7L, R7L, X7L 38" (.97m) OF BASE 88.0 7’...
- Page 10 FromBottom of Base 80.2 FROM BOTTOM OF BASE 18.1 Model A5L, R5L, X5L 63.2 5'8" (1.73m) x 7' (2.03m) x 31" (.79m) Model STIL7 FROM BOTTOM OF BASE 7′-4″ (2.24m) x 7′ (2.13m) 31.6 x 34″ (.86m) 15.3 NOTES: stub up DOOR ENTRY IS CENTERED ON THE FRONT OF THE SPA WITH THE FOLLOWING SPAN: 65.75"...
- Page 11 Hardware Setup/Wiring Diagram M Series (yt9) (North America 60 Hz) YT-9 UL Wiring Diagram Pump 1 (A2) Pump 2 (A3) Pump 3 (C1) Circulation pump / O3 (A1) Voltage 240 V Voltage 240 V Voltage 240 V Voltage 240 V Green / ground Green / ground Green / ground Green / ground Black / low speed Black / low speed Black / low speed K22 Black / low speed Red / high speed Red / high speed Red / high speed K23 White / common White / common White / common...
- Page 12 Hardware Setup/Wiring Diagram M Series (yt9) (Outside North America 50 Hz) YT-9 CE Wiring Diagram Pump 1 (A1) Pump 2 (A3) Pump 3 (C1) Circulation pump / O3 (A2) Voltage 240 V Voltage 240 V Voltage 240 V Voltage 240 V Green / ground Green / ground Green / ground Green / ground Black / low speed Black / low speed Black / low speed K22 Black / low speed Red / high speed Red / high speed Red / high speed K23 White / common White / common White / common...
- Page 13 Connections - 0611-2210112-577 - 0611-221036-565 Hardware Setup/Wiring Diagram A Series & STIL* (yt 7 4.0) Connecting high voltage accessories: North American model in.yt For the connection to the 0.250 inch terminals, the high voltage accessories must be provided with female quick connect terminals, straight and non-insulated for all types of connections, including the ground.
- Page 14 Connections - 0611-221038-567 Hardware Setup/Wiring Diagram R Series & X Series (yt 6) Connecting high voltage accessories: North American model in.yt For the connection to the 0.250 inch terminals, the high voltage accessories must be provided with female quick connect terminals, straight and non-insulated for all types of connections, including the ground. Accessories of 120 V or 240 V may be connected to the corresponding terminals of the printed circuit of the in.yt.
- Page 15 Connections - 0611-221037-566 Hardware Setup/Wiring Diagram A Series & STIL, 50Hz Equipment (yt7) IMPORTANT: See electrical connection and jumper set up on page 47-49 for 1, 2, 3 phase connections. Connecting high voltage accessories: European model in.yt For the connection to the 0.250 inch (6mm) terminals, the high voltage accessories must be provided with female quick connect terminals, straight and non-insulated for all types of connections, including the ground.
- Page 16 Connections - 0611-221039-568 Hardware Setup/Wiring Diagram R & X Series, 50Hz Equipment (yt6) IMPORTANT: See electrical connection and jumper set up on page 47-49 for 1, 2, 3 phase connections. Connecting high voltage accessories: European model in.yt For the connection to the 0.250 inch (6mm) terminals, the high voltage accessories must be provided with female quick connect terminals, straight and non-insulated for all types of connections, including the ground.
- Page 17 GFCI WIRING DIAGRAMS Electrical wiring Electrical wiring: North Amercian model in.ye and in.yt Refer to wiring diagram in the enclosure box lid for more information� 240 V (4 wires) 120 V (*3 wires) * If connected to a 3 wires Note: To convert model to a 120 V system, the white (common) accessory wire must be moved�...
- Page 18 Electrical wiring RCD WIRING DIAGRAMS Electrical wiring: European model in.yt Refer to wiring diagram in the enclosure box lid for more information� Warning in�yt�ce models must always be connected to a circuit protected by a Residual-Current Device (RCD) having a rated operating residual-current not exceeding 30 mA� Correct wiring of the electrical service box, RCD, and pack terminal block is essential! Check your electrical code for local regulations�...
- Page 19 Bullfrog International, LC 668 W. 14600 S. Bluffdale, UT 84065 T: 801.565.8111 F: 801.565.8333 E: info@bullfrogspas.com v 6.1.1 Register your spa online by visiting: bullfrogspas.com/warranty-registration North America 2020 Bullfrog International LC...
Need help?
Do you have a question about the M Series and is the answer not in the manual?
Questions and answers