Advertisement
QUICKSTART
Troubleshooting
1
A
C
2
A
3
A
4
A
5
A
B
B
b
B
B
C
Appliance cannot be started
A Stand-by, turn key switch to "0", then set it
back to "1".
B Release emergency-stop button by turning.
C Battery depleted.
Charge battery.
No or inadequate suction power
A Clean the seals between dirt water reservoir
and cover and check for tightness, replace if
required.
B Clean the vacuum lips on the vacuum bar,
turn or replace if required
C Check suction hose for blockages; clean if
required.
Check connection between suction hose and
suction bar and suction hose and wastewater
tank.
Insufficient cleaning result
A Set/ adjust contact pressure.
B Check brush for wear and tear and clean it.
Check the brushes for wear (bristle length at
least 10 mm), replace if required.
Brushes do not turn
A Set/ adjust contact pressure.
B If over-current switch in the electronics
system has been triggered, turn key switch
to "0", then set it back to "1".
C Check the brushes for blockage due to for-
eign particles, remove them if found.
No or very little detergent solution gets added
A Increase the water volume to activate the
dosing pump.
B Check level of detergent solution in the fresh
water tank; refill, if required.
5.964-036.0 02/11
Advertisement
