Drain Line Installation
If 5/8" x ½" drain line tubing
is used insert the tubing
"insert" into the tubing;
install nut ; push tubing into
the drain line fitting and
tighten nut. Otherwise, PEX
pipe or rigid ¾" or 1" PVC
can be used for the drain.
Note: Drain line fitting is
System Placement
•
Locate water line and determine where to place the unit.
(Be sure placement is near electrical power and a
potential drain.)
•
Install system on main water line before the water heater.
Notes:
Be sure by-pass is closed.
If a filter is also to be installed, install the softener after the
filter.
On two tank systems a hose bib may be useful between the
tanks to test the performance of the first tank.
¾"
male NPT.
9
Insert "insert"
in ½" tubing.
Push tubing in
fitting and
tighten nut.