Error Messages - Safeway water Premium Series Owner's Manual

Error Messages

To go back to factory settings follow these
directions:
Press NEXT and REGEN together for 3 to 5 seconds (release when
motor starts).
Wait until the screen says: SALT REMAINING UNKNOWN.
Now, press NEXT, NEXT, NEXT until you get to CAPACITY REMAINING .
Then, press SET. Then PRESS and HOLD the UP and DOWN arrow
buttons to restore programming to factory settings. After this process,
the screen will eventually say SALT REMAINING UNKNOWN.
Other messages:
ERROR -MAV TOO LONG
Here, the valve is set up for a second motorized valve, but no
motorized valve is installed.
(You are set up in the wrong mode, check your settings; check filter
valve's plug connections.)
Press NEXT and REGEN and HOLD.
IF VALVE APPEARS TO BE LOCKED:
If it appears a valve is locked, press in sequence: ARROW DOWN; NEXT;
ARROW UP; SET CLOCK. Then, settings may be viewed and adjusted.
Note: Check if vacation mode is "on". (If it is "on" turn it "off".)
22