Safeway water Premium Series Owner's Manual page 21

Start Up (Continued)
•
Press REGEN again and the valve will move to REGENERANT
DRAW DN cycle. During this cycle watch the level of water in
the brine tank go down. (This observation is essential;
otherwise, the resin will not become cleaned without brine
water.)
•
Press REGEN again and the valve will advance to the second
backwash. (Check drain line for clear water before advancing
to the next cycle.)
•
Press REGEN again and the valve will advance to the Rinse
position. Allow the water to run out the drain until it runs
clear.
•
Press the REGEN button again and the valve will advance to
Service. (The display will read
until several regenerations when the correct data will be
shown.)
Finally:
• Open valve's outlet to supply water to the house.
•
Go in the house and open a faucet. See if water
runs clear.
•
Look for gallons flow in the lower left of the
valve's display.
•
Go back in the house and shut off faucet.
• Add salt to the brine tank
(3-4 bags .)
SALT REMAINING UNKNOWN,
21
Open outlet
slowly to supply
water to the
house..