Sirius XM RAdio TTR1 User Manual page 72

Appendix: Manual Network Configuration
g.
Turn the TUNE Knob to highlight Wired .
Press the TUNE Knob .
h.
Will you be using DHCP? Turn the TUNE
Knob to highlight DHCP enable or DHCP
disable and press the TUNE Knob .
i.
If you have selected DHCP disable, enter
the following information . Otherwise, continue with step j .
For each entry, Turn the TUNE knob to select the numbers, and press
the TUNE knob to confirm and move to the next number . Press BACK if
you entered an incorrect number .
TIP! You can use the Remote Control to increment the numbers (
forward or backward through the number fields ( + and —) .
i . Enter the IP address to use for the Radio .
ii . Enter the Subnet Mask IP address for the network .
iii . Enter the Gateway IP address for the
network .
iv . Enter the Primary DNS IP address for
the network .
v . Enter the Secondary DNS IP address
for the network, or leave blank if there
is none .
j.
If you have entered the correct information, and the Radio is able to
connect to your network, the Connected screen will be displayed . If
not, the Failed to connect screen is displayed . This means that one or
72
Connection type
Wired
Wireless
), and move
IP settings
IP address
. 0 . 0 . 0
0
Subnet mask
255 255 . 255 . 0 .
1/9
>
>