Operating Guide; Charging; Turning On And Off - INVISIBLE FENCE Shields Gate Owner's Manual

Operating Guide

Important: Fully charge unit before initial use. To ensure your pet does not receive an
unintended correction, make sure your pet is not wearing the Computer Collar® Unit when
turning ON or adjusting The Shields® Gate transmitter.
Charge the Shields Gate
• Locate the charging jack on the front edge of the unit near the power button. Connect the
charger connector to the charging jack with the keyed side facing up.
• Plug the AC adaptor (RAC00-13701) into a standard 120 volt wall outlet.
• Allow the unit to fully charge before initial use and after prolonged storage. A charge time
of 2 hours is required for normal charging.
o The power button will illuminate red while charging.
o The power button will illuminate green when charging is complete.
• Battery life of approximately 30 days can be expected from a fully charged battery.
• The Shields Gate transmitter will give an audible chirp once every 30 seconds and the power
button will flash red every 5 seconds when the battery is low and charging is required.
Power Button
Charging Jack
Mounting Keyhole
1 each side
Turning ON and OFF Shields Gate:
• Turn ON by pressing and holding the power button until the power button turns from red to
green (approximately 2 seconds). Release the power button. Unit will emit a single beep.
• Turn OFF by pressing and holding the power button until the power button turns from red to
OFF (approximately 5 seconds). Release the power button.
Motion Sensors
TOP VIEW
LCD Display
Control Panel Cover Screw
BOTTOM VIEW
InvisibleFence.com
Linking
Contacts
2 each side
6