Intec FORCE/2 Installation Instructions Manual page 8

Support the back of the electrical
box as shown.
S
T
E
P
49
Align circular connector to flange
receptacle on electrical box. Turn
the outer ring of the circular con-
nector clock-wise until it stops.
OUTER RING
TURN CLOCKWISE
TO TIGHTEN
S
T
E
P
52
Note: Outer ring of connector will not
tighten unless properly aligned!
Attach the antenna mount as
shown below using the same 1/4"
bolt & nut.
S
T
E
P
55
While supporting the electrical box
align holes and install the (2) #6
screws from step 4 using a #2 Phil-
lips screw driver.
S
T
E
P
50
At the airlock locate and remove
the 1/4" bolt as shown below using
(2) 7/16" open end wrenches.
S
T
E
P
53
1/4" bolt
At this point, antenna mount should
be secure as shown.
S
T
E
P
56
Once the electrical box is secured
to the base, re-attach the electrical
panel to the base using the (6) #8
screws from step 3.
S
T
E
P
51
Locate antenna mount as shown.
S
T
E
P
54
Attach one end of the cable to the
antenna mount on the electrical
box, as shown.
S
T
E
P
57
Note: When attaching cable, you will need
to align the connector, push in and turn
clockwise.