Intec FORCE/2 Installation Instructions Manual page 6

Locate and disconnect the white
wire on the Remote Quick Discon-
nect (terminal 1-).
S
T
E
P
31
Connecting Wago terminal on C3
Pic 1 = Opening connector
Pic 2 = Open, ready for wire
Pic 3 = Insert wire
Pic 4 = Close connector
Test pull wire connection
Pic 1 Pic 3
S
T
E
P
Pic 2 Pic 4
34
Insert twisted wires into flanged
inlet as shown. Using a #2 Phillips
tighten screw and verify the wires
are secure by gently pulling on
them.
S
T
E
P
37
Note: May have to rotate circuit breaker to
tighten screw on flange.
Locate the wire marked (U3) on the
remote selector switch and con-
nect it to remote quick disconnect
(terminal 1+).
S
T
E
P
32
Locate the flanged inlet for the
blower. Using a #2 Phillips screw-
driver, remove the black wire as
shown in picture 5 & 6
Pic 5
S
T
E
P
Pic 6
35
BLACK WIRE
REMOVED
Locate the blower flanged inlet.
Using a #2 Phillips screwdriver,
remove the white wire as shown.
See Picture 9 & 10
S
T
E
Pic 9
P
WHITE WIRE
38
REMOVED
Pic 10
Locate the white wire which was
removed in step 31. Using wire
cutters, cut off existing terminal
as shown. Using wire strippers,
strip the white wire back, 3/4", see
photo. Next, attach the stripped
wire to the Wago terminal on C3
from the remote selector switch.
S
T
E
P
33
Note: Do not nick or cut off the wires!
Also, to achieve a good fit you may need to
trim off excess wire.
Locate the black wire on the wire-
less remote receiver. Twist together
the black wire from the flanged
inlet and wireless remote receiver,
see picture 7 & 8.
Pic 7
S
T
E
BLACK WIRE
P
Pic 8
36
Locate the white wire on the wire-
less remote receiver. Twist together
the white wire from the flanged
inlet and wireless remote receiver,
see picture 3 & 4.
Pic 11
S
T
E
WHITE WIRE
P
Pic 12
39