Installation Instructions; Tools Needed - Intec FORCE/2 Installation Instructions Manual

Effective 7/19/2010
Note: This wireless kit will only fit on
those machines manufactured after
4/2005, see lower left hand corner of
the electrical panel for date code.
Turn the Force/2 upside down as
shown.
S
T
E
P
1
Note: Requires two people.

Installation Instructions

Electric drill, 3/16, 3/8, & 1/2"drill bit, #2 Phillips screwdriver, center
punch, hammer, wire cutter/stripper, Qty (2) 7/16", Qty (1) 5/8" and Qty
(1) 11/16"open end wrenches, pliers, rubbing alcohol, clean rag, Qty (2)
2 x 4 x 12" wood pieces and a small flat file.
BEFORE PERFORMING ANY WORK, MAKE SURE
THE FORCE/2 IS NOT PLUGGED INTO AN
ELECTRICAL OUTLET OR INJURY MAY OCCUR!
Locate the circular connector on
the side of the electrical box as
shown. To remove, turn outer ring
of connector, counter clockwise,
pull gently to remove.
Outer ring
S
T
E
P
2
Part Number 21200
(115VAC ONLY)
Approximate install time
(1-2 hours)

Tools Needed

CAUTION!
Using a #2 Phillips screwdriver,
remove the six screws holding the
electrical face panel on the ma-
chine. When finished, set aside the
screws for use during re-assembly.
S
T
E
P
3