Intec FORCE/2 Installation Instructions Manual page 4

At this point, all holes should be
drilled in the electrical face plate,
as shown.
S
T
E
P
13
Remove template and clean shav-
ings from electrical box and set
aside.
S
T
E
P
16
Note: If compressed air is available, blow
out all shavings.
Next, locate the wireless receiver,
remote selector switch and antenna
mount as shown.
S
T
E
P
19
Use alcohol to clean outside of
electrical box, allow to dry before
applying template as shown.
S
T
E
P
14
Re-install both circuit breaker and
seal into newly drilled hole in elec-
trical face plate, as shown. Install
the plastic plug into the original
circuit breaker hole.
CAUTION: Do
not over tighten, hand tighten only!
S
T
E
P
17
Note: Circuit breaker shown
from back of electrical panel.
Mount the wireless receiver to the
back of the electrical panel by slid-
ing the device underneath the wires
as shown. Secure wireless receiver
to the electrical panel by using a #2
Phillips screwdriver and the four
6-32 x 1/4" screws.
S
T
E
P
20
Note: do not over tighten.
Drill pilot hole using 3/16" drill bit.
Next, drill out pilot hole using 1/2"
drill bit.
S
T
E
P
15
At this point, all holes should be
drilled.The circuit breaker and plug
should also be installed
S
T
E
P
18
Front view of electrical panel: Se-
curing wireless receiver to electri-
cal panel.
S
T
E
P
21