Intec FORCE/2 Installation Instructions Manual page 3

Carefully remove the electrical
panel as shown. Caution:Do not
pull on the wires! Using a #2 Phil-
lips screwdriver, remove the two
screws holding the electrical box,
see arrows.
S
T
E
P
4
Note: Make sure to support the electri-
cal box while removing the two mounting
screws. When finished, set screws aside
for use during re-assembly.
Remove the clear circuit breaker
seal by turning counter clockwise.
Push circuit breaker through the
panel and set aside.
S
T
E
P
7
Note: Circuit breaker shown
from back of electrical panel.
Before center punching panel, place
a 2 x 4 underneath electrical panel
for support. Center punch all (6)
drill point areas.
S
T
E
P
10
During removal of electrical box
and panel, make sure to support the
electrical box as shown.
S
T
E
P
5
Place the electrical box with the
panel facing up, lift the control
panel up and flip it to the left.
S
T
E
P
8
Pilot drill all (6) center punched
areas using the 3/16" bit, then drill
holes as indicated on the template.
S
T
E
P
11
Slide the electrical panel through
opening in base as shown. Once
you have successfully guided the
electrical panel though the hole,
remove electrical box and panel.
S
T
E
P
6
Use alcohol to clean the back of the
control panel, allow to dry. Apply
drill template as shown.
S
T
E
P
9
Hint: Use the two mounting holes
for alignment.
When finished, de-burr all drilled
holes, remove template and clean
out any metal shavings which may
have fallen into electrical box.
S
T
E
P
12