SET UP THE FRONT SIDE OF THE POWER SUPPLY
Look to the front on the Orion to power on the welder and control the touch screen .
Microscope Arm Setup
MICROSCOPE ARM MOUNTING OPTIONS
•
Remove the microscope arm from the box and place it on your
table .
•
Follow the desired mounting method below .
Mounting Option 1 - Clamp to table
•
Determine the height of the tabletop . *If it is thicker than 3-1/2'
(9cm), follow mounting options 2 or 3 .
•
Position the microscope arm clamp under the tabletop .
•
Turn the clamp knob clockwise until the clamp is very snug .
Mounting Option 2 - Bolt through table
•
Using a 4mm (5/32) allen wrench, unscrew the allen bolts
holding the clamp to the arm .
•
Run the included 8mm (5/16) bolt (F) through the included
plate (H) .
•
Attach plate (H) to the bottom of the arm using the same
allen bolts from step 1 .
•
Drill a 3/8' (9 .5mm) hole through the tabletop .
•
Lower the arm so the bolt goes through the hole in the table
top .
•
Slide the tightening plate onto the bolt and then tighten the
twist knob onto the bolt until it is very snug .
•
Plug the pulse arc welding alligator clip in the port at the bottom right of the welder .
Alternatively, you may use the "Pulse Arc and Tack +" port on the back of the welder .
•
Push in the power button on the bottom left to start the welder .
•
Touch the play button on the user interface to begin welding .
OrionWelders.com
5