What Is In The Box; Power Supply Setup - Orion c Series User Manual

c Series User Manual
Chapter 1: Welder Setup & Assembly

What is in the Box

ALL ORION C SERIES SYSTEMS COME WITH:
(1) Safety Manual & Quick Start/Quick Settings Guide
(1) Orion c Series Power Supply
(1) Welder Power Cord
(1) Stylus Hand Piece
(2) Alligator Clips
(1) Foot Pedal
(1) Shielding Gas Hose
(1) Electrode Vial (5 – 0 .5mm and 5 – 1 .0mm Electrodes)
(2) Microscope Eye Piece Shields
(1) Fiberglass Brush
(1) Cross Lock Tweezers
(1) System Cover
(1) Brass Lined Pliers
IF YOU PURCHASED THE MICROSCOPE ARM SYSTEM:
(1) Orion Microscope Arm
(1) Microscope Arm Table Mount
(1) Microscope Arm Support Bar
(1) Set of Allen Wrenches

Power Supply Setup

SET UP THE BACK SIDE OF THE POWER SUPPLY
The Orion has an internal switching power supply that can accept both 120 and 240VAC .
•
Plug the female end of the power cable into the "90-240 VAC" Power port .
•
Connect the male end of the power cable into AC power .
•
Insert the 1/4" gas tube firmly into the "Shield Gas" port . *It may wiggle when
connected, but should not come out if pulled on .
•
Plug the foot pedal into the "foot pedal" port .
•
Plug the RJ45 microscope cable into the "Shutter" port on the back of the power
supply .
•
Push the stylus into the stylus connector port on the back panel of the power
supply . Ensure that the white circular indicator on the stylus lines up with the
white indicator on the stylus port . The connector will snap into place .
•
When pulse arc welding with the weld stylus, connect an alligator clip to the
"Pulse Arc and Tack +" port on the back of the welder . (If you do not use this port,
use the one on the front of the welder) . *Remember to attach the alligator clip to
the work piece before pulse arc welding .
•
When Tack welding, plug one alligator clip into the "Pulse Arc and Tack +" port and
one into the "Tack -" port . *Remember to attach each alligator clip to each work
piece before Tack welding them together .
4
IF YOU PURCHASED THE DARKENING LENS
SYSTEM:
(1) Base Plate and Phillips Screw
(1) Base Plate Stand and Cap
(1) Darkening Lens
(1) Darkening Lens Arm
(1) RJ45 Darkening Lens to Welder Cable