Table of Contents
Advertisement
ENGLISH
SERVICE MANUAL
ELECTRICAL SYSTEM
ELECTRICAL SYSTEM
(WET OR GEL) BATTERY REMOVAL/INSTALLATION AND SETTING [Vantage 17 Battery]
Disassembly
1.
Check that the switches (5 and 6) are turned to "0".
2.
If there is recovery water in the tank (43), drain it through the hose (22).
3.
Disconnect the vacuum hose (29) from the squeegee (17).
4.
Open the cover (12) and apply the cover stand (60).
5.
Grasp the recovery water tank (A) in the area (B) and lift it, as shown in the figure, then disconnect the vacuum hose (C)
from the tank and remove the tank (A) together with the hoses (D) and (E).
6.
Disconnect the battery terminals (50).
7.
Remove the batteries (50).
Setting (WET or GEL) before installation
8.
If the type of battery chosen to be installed is different from the removed one (not WET but GEL, or viceversa), before
installing and connecting the new batteries, the machine electronic board setting must be performed according to the
following procedure.
9.
Remove the screws (F) and carefully pull out the electrical component box cover (G).
10.
Set the microswitch (H) to WET or GEL position according to the type of battery that is to be installed.
WARNING!
Do not move the adjacent switch (I).
11.
Reinstall the electrical component box cover (G) and tighten the screws (F).
Battery assembly
12.
Once the setting is performed, install the batteries on the machine according to the diagram (51).
13.
Connect the battery terminals (50).
Battery charger
14.
Charge the batteries.
Reset
15.
Carry out steps from 3 to 5 in the reverse order.
36
9097182000 - 11/2009
B
C
A
D
VANTAGE 17 Battery / Cable
E
S301369C
Advertisement
Table of Contents
Troubleshooting
