Solution Filter Cleaning; Detergent Mixing System Draining - Clarke RA40 Instructions For Use Manual

Hide thumbs Also See for RA40:
Table of Contents

Advertisement

Available languages

Available languages

SOLUTION FILTER CLEANING

1.
Drive the machine on a level floor.
2.
Ensure that the machine is off and the operator key (41) is turned to "O".
3.
Close the solution tank valve (9). The valve is closed when it is in position (9-B) and it is open when it is in position (9-A).
4.
Remove the transparent cover (A, Fig. 10), retrieve the gasket (B), then remove the filter strainer (C). Wash and rinse them
with clean water, then refit them carefully onto the filter support (D).
5.
Open the valve (9-A).

DETERGENT MIXING SYSTEM DRAINING

(For machines with Detergent Mixing System)
To remove residual detergent from the detergent hoses and pump, proceed as follows.
6.
Turn on the machine by turning the ignition key (41) to "I".
7.
Press the push-button (42). Check that the detergent quantity indicator (48-G) on the display has at least one segment lit.
8.
Press and hold buttons (44) and (45) at the same time until screen (48-K) appears on the display (after approximately 5
seconds).
9.
Release buttons (44) and (45) and wait for the countdown timer on the display to finish and the vacuum system to be activated.
10. Collect the detergent remained on the floor.
11. Turn off the machine by turning the ignition key (41) to "O".
12. Lift the recovery tank assembly (17), then check that the detergent tank hose (38) is empty, otherwise perform steps 3 to 7
again.
NOTE
The draining cycle lasts about 30 seconds, then the vacuum function automatically turns on, which allows to remove the
detergent remained.
The draining cycle can also be performed with the detergent tank (38) full of water, thus cleaning the system thoroughly.
It is advisable to perform this type of draining to clean the Detergent Mixing System from dirt and deposits if the machine
has not been used/cleaned for a long time.
The draining cycle can also be performed to quickly fill the detergent supply hose when the tank (38) is full but the
system is still empty.
If necessary, the draining cycle can be performed several times in succession.
01/2015
INSTRUCTIONS FOR USE
D
B
C
A
Figure 10
9100000394 - RA40
ENGLISH
P100874
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents