Time-Out Timer Pre-Alarm; Battery Save Setup; Priority Scan Setup; Return To Appointed Channel - AnyTone 929 Instruction Manual

BACKGROUND OPERATIONS
using a channel for an extended period of time. If you continuously
transmit for a period of time that exceeds the programmed time set
in advance, the transceiver will stop transmitting with voice prompt.
Users can set TOT timer by programming software.

Time-Out Timer Pre-Alarm

The Time-Out Timer Pre-Alarm is to alarm users that overtime
transmission is pending.
Users can program desired TOT Pre-Alarm time by programming
software.

Battery Save Setup

When this function is enabled, the transceiver can efficiently
reduce battery consumption. The transceiver will automatically
switch on Battery Save Function when not receiving any signal
or making any operations. But when the transceiver receives a
matched signal or make operations, it will automatically exit this
function.

Priority Scan Setup

There are two priority-channel settings of this transceiver,
"fixed" and "selected". Users can set the desired priority scan by
programming software. If transceiver sets priority scan, under
scanning and receiving no signal state, it will scan every channel
and also test priority channel at a time. When the non-priority
channel receives signal, it will test priority channel according to
flyback time "A" and flyback time "B" setup by users.

Return to Appointed Channel

During scan process, press [PTT] key to transmit or stop
scanning, then the transceiver will return to appointed channel.
27