Intercel Smart SAM2W User Manual page 20

Smart SAM2W User Guide V1.2
AT$SMSNUMBER
Set phone number to receive alarm SMS when modem looses power (for Super CAP hardware only), this
command is for serial port entry only.
AT$SMSNUMBER="0418505361"
AT$SMSNUMBER?
$SMSNUMBER: 0418505361
OK
AT$SERIALMODE
Set modem serial mode. This command is for serial port entry only.
AT$SERIALMODE=0
Modem stays in AT Command mode when there is no TCP active connection, modem can response to UDP
data from remote but is not able to initiate an UDP data session to remote server.
AT$SERIALMODE=1
Modem go into online data mode after connected to GPRS, modem can initiate an UDP data session to
remote server.
Use sequence +++ to escape to AT Command mode and ATO to go back to data mode.
Default is 0.
AT$SERIALMODE?
$SERIALMODE: 0
OK
18 Ver1.2