REPAIR
7.4 Cooling System
Water Pump
Removal and Installation
See Figures 7-25 and 7-26.
1
1. Remove cap screws (2) and water pump (1).
7
2. Rotate the water pump pulley and check for noisy
operation, excessive resistance, or play in the pulley
shaft. If any abnormal condition is found, replace the
water pump.
Installation Notes
Always use new O-rings, gaskets, and seals.
Install the water pump with new O-ring, by reversing the
order of removal.
7-10
2
Figure 7-25
Figure 7-26
Thermostat
Removal and Installation
See Figures 7-27 and 7-28.
TN0726
1. Remove cap screws (1).
2. Remove filler neck (2).
3
TN0432
3. Remove thermostat (3).
4. Inspect and test thermostat. Replace as needed.
(See "Thermostat Test" on page 5-3.)
Installation Notes
Clean thermostat housing and filler neck mounting
surfaces of debris before installation.
Install thermostat by reversing order of removal.
2
1
Figure 7-27
Figure 7-28
TN0701
TN0705