7.8 Cylinder Block and Lower
Crankcase
Knock Sensor
Removal and Installation
See Figure 7-86.
2
3
1
Figure 7-86
1. Use a small screwdriver to depress internal tab (2)
and release electrical connector (3) from bracket (1).
2. Remove knock sensor (4) from cylinder block.
3. Inspect and replace as needed.
Installation Notes
Install knock sensor by reversing the order of removal.
Tighten knock sensor to specification.
Knock Sensor Torque: 203 lb-in. (23 N•m)
4
TN0718
Crankshaft Pulley
Removal and Installation
See Figure 7-87.
1
2
Figure 7-87
1. Remove cap screw (1) and crankshaft pulley (2).
2. Inspect and replace as needed.
Installation Notes
Install crankshaft pulley by reversing the order of
removal.
Tighten crankshaft pulley cap screw to specification.
Crankshaft Pulley Cap Screw: 72 lb-ft (98 N•m)
REPAIR
TN0721
7
7-37